Handball

[FrontPage Include Component] Previous
Home
Up
Next

NAVIGATOR: Back - Home > Adi > Services > Library > Articles :

Home

Handball

Up
Panning
Handball
Muscle Fiber

Categories

Products
Services
Site Map
Search
About us

Search

Contact us

General info

+1 949 858 4216

Sales & support

+1 619 992 3089

E-mail

Information

Sales

Support

CHECK OUT

[FrontPage Include Component]

The Relationships between Throwing Velocity and Motor Ability Parameters of High-Performance Handball Players

Jerzy Eliasz, Dept. of Biomechanics, Institute of Sport, Warsaw, Poland

INTRODUCTION

Throwing is one of the most important skills in team handball [Mikelsen and Olesen 1976, Joris et al.1985, Eliasz et al.1990, Muijen et al.1991,Marczinka 1993]. Two basic factors are of importance with regard to the efficiency of shots: accuracy and throwing velocity. Naturally, the faster the ball is thrown at the goal, the less time defenders and goalkeeper have to save the shot. Handball coaches and scientists who have investigated overarm throwing are in agreement that the main determinants of the ball velocity can be divided into three groups concerning technique of motion, somatic features and motor ability (physical fitness), respectively [Pauwels 1978, Eliasz et al.1990, Muijen et al.1991]. Although the technique of motion and the fitness level can be improved by the training process [Eliasz 1993], morphological factors are, in the main part, determined genetically. Since changes in the throwing technique among high-performance players are very small, it was assumed as constant during short period of training process.

The aim of the research was to find the relationships between the ball velocity during different types of throws in handball and basic motor ability parameters (muscle strength, arm speed) of players, in order to improve the efficiency of training. MATERIAL AND METHODS

Twelve high-performance handball players took part in the experiment (six of them were at that moment members of the National Team). The average values of basic parameters of physical characteristics of the subjects were: 89.0�7.8 kg (body mass), 1.88�0.05 m (body height) and 23.3�2.5 years of age. The Shapiro-Wilk test, Pearson's correlation matrix and multiple regression analysis were used (a=0.05).

Measurement of the ball velocity

In order to assess the overarm throwing performance, a standard handball was used (mass 480 g, circumference 58 cm). The subjects were instructed to throw the ball as fast as possible at a target (50 x 50 cm) placed at a distance of about 6 meters [Pauwels 1978, Eliasz et al.1990]. Each subject performed trials until three registered throws (i.e. when the ball hit the target) were achieved. The average linear ball velocity was measured over a 2 meter distance using a special photocells system [Eliasz et al.1990]. Handballers performed three of the most popular types of throws: on the spot, with a cross-over step and with an upward jump [Marczinka 1993]. Each session was preceded by 10-minute standard warm-up.

Measurement of the muscle torques under static conditions

The muscle strength was evaluated on the basis of the sum of muscle torques developed by main muscle groups under static conditions (ISI - isometric strength indicator). In the measurements was used the isometric muscle torque stand (local make), which enabled the direct measuring of torques for flexors and extensors of elbow, shoulder, knee and hip joints and flexors and extensors of trunk. Angle positions for all joints were 90 deg (with 180 deg meaning full extension) with the exception of shoulder joint (45 deg). The stand enabled to measure each group of muscles with simultaneous elimination of the influence of any other forces on the result [Jaszczuk et al.1987].

Measurement of the muscle torque under dynamic conditions

The measurements were carried out on the Ariel Computerized Exercise System ACES modified in its mechanical part (the Arm-Leg Station). Subjects performed simulated throws in the sitting position, propelling the bar of the Arm-Leg Station [Ariel 1991]. The movement was similar to the last phase before the release of the ball during a real throw. Each subject executed three kinds of tests: maximal speed diagnostic (MSD), isokinetic exercises (IKE) at angular velocities 100, 300 and 500 deg/s, isotonic exercises (ITE) at external torques 10, 30 and 50 N�m.

The following parameters were chosen to further the analysis: maximal angular velocity of the bar measured during MSD, maximal and average mechanical power during IKE and ITE, maximal and average torque developed in IKE, maximal and average angular velocity measured in ITE.

Counter-Movement Jump

The maximal mechanical power of the lower extremity and trunk was measured during the vertical counter-movement jump performed on a force platform [Dowling and Vamos 1993]. The signal (force) was processed on-line (IBM PC). Five parameters were chosen in order to estimate speed-strength characteristics of the lower extremity of the handball players: Pmax-maximal mechanical power [W], Pave-average mechanical power [W], Hmax-maximal height of the jump [m], t-time of the take-off [s], P/m-maximal power related to body mass [W/kg].

RESULTS

The highest value of linear throwing velocity the ball has achieved after throw with cross-over step and the differences between this value and velocities measured during throws on the spot and with an upward jump were statistically significant. The results are shown in Table 1 Tab.1. Maximal value of ball velocity [m/s] during different types of throwing (mean values for n=12).



Multiple regression

DISCUSSION

Among many different throws in team handball the most often used during the game is throw with an upward jump [Eliasz et al.1990, Marczinka 1993]. Although the ball velocity measured after this kind of throw does not reach the highest value (see Tab.1) and throwing technique is far more complicated then that of the other analyzed throws jump [Eliasz et al.1990, Marczinka 1993], the popularity of throw with jump is due to its efficiency [Eliasz 1993]. The ball velocity values showed in Table 1 are similar to those which have been obtained by others [Mikelsen and Olesen 1976, Filiard 1985, Eliasz et al.1990], even though the average velocity was measured along two meters distance and the first photocell gate was placed two meters from the thrower. The maximal value of the ball velocity can be measured during release using radar [Mikelsen and Olesen 1976, Pedegana et al.1982, Filiard 1985, Bartlet et al.1989] or cinematography (especially 3-D), which is a very time-consuming but still popular method in biomechanics [Atwater 1980, Filiard 1985, Joris et al.1985, Feltner and Dapena 1986, Muijen et al.1991, Best et al.1993, Coleman et al.1993, Sakuraj et al. 1993, Whiting et al.1993].

The highest value of ball velocity measured during throw with a cross-over step can be explain on biomechanical basis. During this type of throw the motion direction of player's center of gravity is consistent with the direction of ball flight, so it has an initial velocity before release. The results of strength assessments (both under static and dynamic conditions) can not be directly compared to others results because the unconventional measurements procedure was applied.

Many researchers who have investigated an overarm throw, have indicated that muscle strength is a very important factor influencing throwing velocity [Pauwels 1978, Pedegana et al.1982, Amin et al.1985, Pawlowski and Perrin 1989, Renne et al.1990, Wooden et al.1992, Bartlet et al.1993, Eliasz 1993, Marczinka 1993]. In this work statistical analysis has shown that the muscle strength of trunk flexors is one of the most significant velocity determinant in analyzed throws (this variable is in all presented equations). There are abdominal muscles: rectus abdominis, external and internal oblique muscles. All these muscles, acting together, are involved in forward bending but trunk rotation is caused by one-side shortening action of external and internal oblique muscles. Both type of motions can be observed during throwing before release [Atwater 1980, Joris et al.1985, Eliasz 1993, Marczinka 1993].

The investigation has some practical applications. There are two main possibilities to improve throwing velocity, probably in all techniques used in handball: (1) by development abdominal muscles strength and (2) by improvement speed of external and internal rotation at shoulder joint. The last can be achieved, for example, by using a lighter ball during training [Joris et al.1985, Eliasz 1993]. All these statements need practical verification in the training process.

CONCLUSIONS

bullet1. Statistically significant differences were found between maximal ball velocity during throws with a cross-over step, and ball velocities during other analyzed throws. The highest ball velocity was achieved during the throw with a cross-over step performed by play-makers.
bullet2. Among the motor ability factors, total muscle strength of the body (ISI), strength of trunk flexors (abdominal muscles) and maximal arm (shoulder joint) angular velocity (MSD) have a decisive effect on the ball velocity in analyzed throwing techniques.
bullet3. The maximal arm speed is the most important factor determining ball velocity during - technically the simplest - throw on the spot. Muscle strength has greater influence on ball velocity during - technically more complicated - throw with an upward jump.

REFERENCES

bulletAmin W.K.M., Horyd T., Bober T. (1985): Strength characteristics of team handball players. In: Biomechanics in Sports II, Terauds J.,Barham J.N./Ed./. Acad. Publishers, Del Mar, CA:379-384.
bulletAriel Computerized Exercise System User's Manual (1991). Life Systems Inc., La Jolla, CA, USA.
bulletAtwater A.B. (1980): Biomechanics of overarm throwing movements and of throwing injuries. Exer. Sport Sci. Rev. 7:43-85.
bulletBartlett L.R., Storey M.D., Simons B.D. (1989): Measurement of upper extremity torque production and its relationship to throwing speed in the competitive athlete. Am.J.Sports Med. 17:89-91.
bulletBest R.J., Bartlett R.M., Morriss C.J. (1993): A three-dimensional analysis of javelin throwing technique. J. Sports Sci.11:315-328.
bulletColeman S.G.S., Benham A.S., Northcott S.R. (1993): A three-dimensional cinematographical analysis of the volleyball spike. J. Sports Sci. 11:295-302.
bulletDowling J.J., Vamos L. (1993): Identification of kinetic and temporal factors related to vertical jump performance. J. Appl. Biom. 9:95-110. Eliasz J. (1993): Trening si�y mi�œniowej w pi�ce r�cznej. Sport Wyczynowy 9/10:21-28.
bulletEliasz J., Janiak J., Wit A. (1990): Pr�dkoœï¿½ lotu pi�ki podczas rzut�w w pi�ce r�cznej. Sport Wyczynowy 9/10:17-23.
bulletFeltner M., Dapena J. (1986): Dynamics of the shoulder and elbow joints of the throwing arm during a baseball pitch. Int. J. Sport Biom. 2:235-259. Filliard J.R. (1985): Contribution a la mesure de la vitesse du tir en hand-ball. Universite de Paris-Sud, Paris:2-37.
bulletJaszczuk J., Buczek M., Karpi�owski B., Nosarzewski Z., Wit A., Witkowski M. (1987): Set-up for measuring in static conditions. Biol. Sport 4:41-55.
bulletJ�ris H.J.J., Muijen Van E., Ingen Schenau Van G.J., Kemper H.C.G. (1985): Force, velocity and energy flow during the overarm throw in female handball players. J. Biom. 18:409-414.
bulletMarczinka Z. (1993): Playing Handball. Trio Budapest Publishing Company. I.H.F.
bulletMikkelsen F., Olesen M.W. (1976): Handbold. Trygg-Hansa, Stockholm. Muijen Van A.E., J�ris H., Kemper H.C.G., Ingen Schenau Van G.J. (1991): Throwing practice with different ball weights: effects on throwing velocity and muscle strength in female handball players. Sports Training, Med. Rehab. 2:103-113.
bulletPauwels J. (1978): The relationship between somatic development and motor ability, and the throwing velocity in handball for secondary school students. W: Shepard R.J. and Lavalle H./Ed./ Physical fitness assessment:principles, practice and application, Springfield, Ill.,Thomas :211-221
bulletPawlowski D., Perrin D.H. (1989): Relationship between shoulder and elbow isokinetic peak torque, torque acceleration energy, average power and total work and throwing velocity in intercollegiate pitchers. Athletic Training 24:129-132.
bulletPedegana L.R., Elsner R.C., Roberts D., Lang J., Farewell V. (1982): Relationship of upper extremity strength to throwing speed. Am. J. Sports Med. 10:352-354.
bulletRenne de C., Ho K., Blitzblau A. (1990): Effects of weighted implement training on throwing velocity. J. Appl. Sport Sci. Res. 4:16-19.
bulletSakuraj S., Ikegami Y., Okamoto A., Yabe K., Toyoshima S. (1993): A three-dimensional cinematographic analysis of upper limb movement during fastball and curveball baseball pitches. J. Appl. Biom. 9:47-65.
bulletWhiting W.C., Puffer J.C., Finerman G.A., Gregor R.J., Maletis G.B. (1985): Three-dimensional cinematographic analysis of water polo throwing in elite performers. Am.J.Sports Med. 13:95-98.
bulletWooden M., Greenfield B., Johanson M., Litzelman L., Mundrane M., Donatelli R.A. (1992): Effects of strength training on throwing velocity and shoulder muscle performance in teenage baseball players. J. Orth. Sports Phys. Therapy 15:223-228.
 

Previous Up Next

This page was last modified on 12/07/2008 at 22:47 PST. Copyright � 1994 - 2002, all rights reserved, Ariel Dynamics Inc. Please send your comments or feedback to webmaster@arielnet.com or proceed to our feedback form. This page has been accessed many times since Dec 12, 2002. Our privacy policy is here.